Zahra Mirkazehi; Mohammad Reza Rezaei; Mohammad Sayadi
Abstract
Landfill leachate is the fluid percolating through the landfill and is one of the most important environmental challenges that lead to the contamination of water and soil resources. In this study, magnetic graphene oxide nanoparticles with WO3 (GO-Fe3O4/WO3) were synthesized through the hydrothermal ...
Read More
Landfill leachate is the fluid percolating through the landfill and is one of the most important environmental challenges that lead to the contamination of water and soil resources. In this study, magnetic graphene oxide nanoparticles with WO3 (GO-Fe3O4/WO3) were synthesized through the hydrothermal method to eliminate chemical oxygen demand (COD) from leachate. The obtained products were characterized using X-ray diffraction (XRD), Fourier Transform Infrared Spectroscopy (FTIR), Scanning Electron Microscopy (SEM), Thermogravimetric analysis (TGA), and Vibrating sample magnetometer (VSM) analysis. The influence of various operating parameters, such as initial solution pH, adsorbent dosage, contact time, and temperature, on COD removal was studied. Additionally, kinetic, isotherm, and thermodynamic studies were conducted to evaluate the adsorption capacity of the adsorbent. The results revealed that the maximum adsorption capacity of GO-Fe3O4/WO3 was 2500 mg/g adsorbent at pH 4, a contact time of 90 minutes, an adsorbent dosage of 25 mg g-1, and a temperature below 298 K, respectively. According to the adsorption kinetic fitting results, the experimental adsorption data were well described by the pseudo-second order kinetic with an R2 value of 0.97, and the Freundlich isotherm equation with an R2 value of 0.99. The thermodynamic results indicated that the adsorption was spontaneous and exothermic for COD adsorption. In general, the adsorption process of the synthesized GO-Fe3O4/WO3 nanocomposite revealed that it is highly effective for landfill leachate treatment and has great practical value in leachate treatment.
Reza Jazini Zadeh; Mohammad Sayadi; Mohammad Reza Rezaei
Abstract
The present study was performed on the adsorption of 2,4-Dichlorophenoxyacetic acid from aqueous solutions by amine-modified magnetic nanoparticles. The adsorbent was synthesized by the co-precipitation method. The adsorbent properties of Fe3O4@SiO2-NH2 were investigated using XRD, FTIR, TGA, VSM and ...
Read More
The present study was performed on the adsorption of 2,4-Dichlorophenoxyacetic acid from aqueous solutions by amine-modified magnetic nanoparticles. The adsorbent was synthesized by the co-precipitation method. The adsorbent properties of Fe3O4@SiO2-NH2 were investigated using XRD, FTIR, TGA, VSM and TEM. Adsorbent efficacy was studied by investigating the effect of pH, initial concentration of pollutants, and adsorbent dose, and times. Finally, kinetics equations and isotherms models were used to describe the data. The results showed that the highest removal percentage was observed at pH 6 and the initial concentration 20 mg/l of 2,4-Dichlorophenoxyacetic acid. Adsorption capacity was increased by 65.3% bypassing the time from the beginning of the process to 60 min. The results from the study of isotherms and adsorption kinetics presented that the sorption procedure follows the pseudo-second-order kinetics and the Langmuir isotherm with R2> 99. The maximum adsorption capacity of Fe3O4@SiO2-NH2 is 116.3 mg/g. Besides, thermodynamic studies have shown that the adsorption process in the present study is endothermic and spontaneous. The experiments showed that Fe3O4@SiO2-NH2 synthesized nanoparticles could be an excellent method to remove 2,4- Dichlorophenoxyacetic acid contaminants from the aqueous solutions due to the high efficiency, simplicity, and lack of secondary contamination in the solution.
)